Carbon monoxide alarm with display Kidde K7DCO

Carbon monoxide detector with display K7DCO is equipped with a Kidde electrochemical sensor, guaranteeing 10 years of operation. Battery power supply allows the detector to be mounted in an optimal place in the room and provides protection also in the event of a power failure in the network.

The built-in LCD display shows the concentration level of carbon monoxide in the range from 0 to 999 PPM. CO concentration measurements are performed every second. Exceeding the permissible CO level is signaled optically (red LED) and acoustically (loud, pulsating sound alarm with a strength of 85dB).

The detector has a test / reset button that allows you to check the device's operation and reset the alarm signal, as well as a button when pressed, which displays the highest detected CO level stored in the device's memory. The detector also has the function of informing about the activation of the alarm in the last 14 days. Thanks to this, the user can make sure that there is no emission of carbon monoxide during his absence in the room.

The efficiency control system monitors on an ongoing basis, among others: the sensor, internal circuits and the state of the battery. In the event of a malfunction or low battery level, the yellow LED blinks, the LCD panel displays the appropriate graphic information and an audible signal sounds. In addition, the device is equipped with a simulation test function that allows you to quickly check the correct response of the device to the CO test gas.

Thanks to the special shock-resistant design, the detector has been approved for use not only in houses and apartments, but also in caravans, motorhomes and boats. After 10 years from the activation of the power supply, the detector will remind you to replace the device.

K7DCO is marked with the construction mark B confirming compliance with the requirements of the Polish standard PN-EN 50291-1: 2018+AC:2021 for home carbon monoxide detectors. The research was carried out by the Scientific and Research Center for Fire Protection - National Research Institute (CNBOP-PIB). In addition, it has a BSI certificate confirming compliance with the requirements of BS EN 50291-1:2018 issued by the British Standards Institution.

In addition, the K7CO detector is certified to meet the requirements of BS EN 50291-2: 2019 (PN-EN 50291-2: 2020) and allows the device to be used in camping vehicles and boats. Compliance with the above-mentioned standard has been confirmed by an independent research unit of the British Standards Institution.

ADVANTAGES

• Electrochemical technology - one of the most precise electrochemical sensors in the world
  
• LCD display with a maximum indication of 999 PPM
• 40% longer service life compared to other detectors on the market
• Loud alarm signaling
• Test / Reset button - for checking and operating the device
• Peak Concentration Button - for reading the highest detected CO concentration stored in the memory
• Battery powered for protection also in the event of a power outage
• Possibility of wall mounting or placing the detector on a flat surface
• Signaling of incorrect work and the end of the period of operation
• Low voltage indication
• Additional LED diode signaling incorrect operation of the device and the end of the service life
• Function informing about the activation of the alarm in the last 14 days
• Simple assembly and operation
• Certification for use in homes and caravans, motorhomes and boats
• Small dimensions, low weight, aesthetic and durable housing
• Very low cost of operation
• Construction mark B
• National Certificate of Constancy of Performance confirming compliance with the Polish standard PN-EN 50291-1: 2018+AC:2021
• BSI certificate confirming compliance with the BS EN 50291-1:2018
• BSI certificate confirming compliance with BS EN 50291-2:2019
• 10-year warranty