Smoke & carbon monoxide alarm K10SCO

K10SCO is a dual smoke and carbon monoxide detector equipped with a voice alarm and two independent sensors. Optical is responsible for detecting fire alarms, while electrochemical is responsible for detecting carbon monoxide (CO).

If a fire is detected and/or the permissible concentration of carbon monoxide is exceeded, an 85dB acoustic alarm is triggered, an optical alarm (red LED ) and a voice notification is emitted (in English) informing about the type of detected threat.

The Test/Reset button allows you to check and operate the sensor. The device's memory stores information about detecting a dangerous concentration of CO or a fire hazard. Thanks to this, the user can check whether there has been any carbon monoxide emission during absence in the room.

K10SCO can be mounted both on the ceiling and on the wall. It is powered by 2 x 1.5V AA alkaline batteries. This solution allows the sensor to be installed in the optimal place in the room and provides protection also in the event of a power failure in the network. The built-in automatic health check system constantly monitors, among other things, condition of sensors and internal circuits. If a fault is detected, the signaling corresponding to the fault is activated.

K10SCO is a device that meets both the PN-EN14604:2006P (EN14604:2005) standard for home smoke detectors and the EN50291-1 standard :2018 for home carbon monoxide detectors. Fulfillment of the above standards has been confirmed by an independent, notified research unit TÜV Rheinland. The device is covered by a 10-year warranty. Also after 10 years from power activation, it will inform you that the device needs to be replaced.

Recommended installation locations: near the kitchen, in the living room, living room, dining room, bedroom, basement, in the attic and places where electrical devices that can be a source of fire and devices that are a potential source of fire are used carbon monoxide e.g. fireplace, electric or gas space heaters, etc.

ADVANTAGES

• Kidde's patented electrochemical sensor for detecting carbon monoxide
  
• Kidde's high-quality optical sensor dedicated to detecting fire hazards
• Lengthened by at least 40% working time in compared to the majority of sensors available on the market
• Loud alarm and visual signaling in the form of an electroluminescent LED diode
• Voice messages distinguishing the detected threat
• Test button / Reset for control and operation of the device
• Hush® function to mute the acoustic signal of the fire alarm
• Battery powered provides protection also in the event of a power failure
• Special design for ceiling or wall mounting
• Mechanism protecting against accidental disassembly of the sensor
• Discharged batteries signaling
• Incorrect operation and end of life signaling
• Simple installation and operation
• Compliance with PN-EN 14604:2006 (EN14604:2005) confirmed by an independent, notified research unit TÜV Rheinland
• TÜV Rheinland certificate confirming compliance with EN50291-1:2018
• 10-Year Warranty